Subject: -ei limited to 12.50% ?
From: Eric Dantan Rzewnicki (eric_AT_zhevny.com)
Date: Tue Sep 21 2004 - 05:16:37 EEST
I haven't seen this before, and I'm not sure why I'm getting it ...
If I understand my commandline correctly I'm not actually asking -ei to
go below 12.5%. I think what I have here should vary between 25% and
1300% at a rate that varies between .1 and 10 Hz at a rate of .2 Hz. So,
I don't think it should be going near 12.50% at all.
Anyway, it still works despite the warning and creates a file that
sounds totally awesome! :-D I'm using this with cassette and miniDV
recordings. I've started recording both left and right channels, then
postprocessing both channels with the same -ei -kos -kx -kos chain
settup, reversing the right channel and mixing the 2 sides together.
It's pretty darn cool!
-Eric Rz.
eric_AT_audiobox:/mnt/audio/in_progress/cassette$ ecasound
-i:2004-0917-cassetter.wav -o:2004-0917-cassetter-m.wav -ei:0
-kos:1,25,1300,0,0 -kx -kos:4,0.1,10,0.2,0
****************************************************************************
* ecasound v2.3.4-pre20040905 (C) 1997-2004 Kai Vehmanen
****************************************************************************
- [ Session created ] ------------------------------------------------------
- [ Chainsetup created (cmdline) ] -----------------------------------------
(audiofx_misc) WARNING! Shift-% must be greater than 12.50%! Limiting to
the low-limit.
(audiofx_misc) WARNING! Shift-% must be greater than 12.50%! Limiting to
the low-limit.
- [ Connecting chainsetup ] ------------------------------------------------
(eca-chainsetup) 'nonrt' buffering mode selected.
(eca-chainsetup) Audio object "2004-0917-cassetter.wav", mode "read".
(audio-io) Format: s24_le, channels 1, srate 48000, interleaved.
(eca-chainsetup) Audio object "2004-0917-cassetter-m.wav", mode
"read/write".
(audio-io) Format: s24_le, channels 1, srate 48000, interleaved.
- [ Chainsetup connected ] -------------------------------------------------
(eca-controller) Connected chainsetup: "command-line-setup".
- [ Controller/Starting batch processing ] ---------------------------------
(audiofx_misc) WARNING! Shift-% must be greater than 12.50%! Limiting to
the low-limit.
- [ Engine init - Driver start ] -------------------------------------------
- [ Controller/Batch processing finished ] ---------------------------------
(eca-controller) Disconnecting chainsetup: "command-line-setup".
- [ Chainsetup disconnected ] ----------------------------------------------
This archive was generated by hypermail 2b28 : Tue Sep 21 2004 - 05:16:50 EEST