Re: [ecasound] How to start a chain in a certain position?

New Message Reply About this list Date view Thread view Subject view Author view Other groups

Subject: Re: [ecasound] How to start a chain in a certain position?
From: Luis Pablo Gasparotto (luispagasparotto_AT_yahoo.com)
Date: Fri Oct 19 2001 - 03:59:52 EEST

El Mié 17 Oct 2001 19:14, escribiste:
> On Mon, 8 Oct 2001, janne halttunen wrote:
> >> The ewf-format can handle offsets when in output mode. So instread of
> >> writing to xxx.wav, write to xxx.ewf. Something like:
> >
> > Hey, this is a cool feature! Ofcourse I have an improvement
> > suggestion. (what are they called, edi's?)
> > What if there could be a check if the vocals.ewf file already existed,
> > and if it did, the engine could start the recording at the offset
> > specified in that file?
>
> Hmm, do you have some specific use-case in mind?
>
> This feature might be a bit confusing - what happens when you issue
> "setpos", "fw" and similar command in iactive mode...?
>
> Or were you thinking about limiting ecasound's access to only certain part
> of an audio file...? So something like:
>
> foo.ewf:
> --cut--
> source = foo.wav
> limit-start = 60
> limit-end = 120
> --cut--

Yes this is what I mean.

> ecasound -i foo.ewf -o bar.wav
>
> .... would be equal to:
>
> ecasound -i foo.wav -y:60 -o bar.wav -t:60
>
> Btw; The ewf-field name 'source' is not very good. Maybe just
> rename it to 'file' or more generic 'object'?

Thank you very much,

Luis Pablo

_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com 

--
To unsubscribe send message 'unsubscribe' in the body of the
message to <ecasound-list-request_AT_wakkanet.fi>.

New Message Reply About this list Date view Thread view Subject view Author view Other groups

This archive was generated by hypermail 2b28 : Fri Oct 19 2001 - 07:28:14 EEST