Subject: [ecasound] the enm effect
From: Jeremy Hall (jhall@uu.net )
Date: Wed Oct 06 1999 - 16:30:00 EEST
Hi,
I am trying to use the enm effect, but am having trouble determining which
values t use. The manpage suggests that the first parameter is a
percentage
...skipping...
-enm:threshold_level_%,th_time,attack,hold,release
Noise gate (mono-summed signal used to control the
gate). When signal amplitude falls below 'thresh-
old_level_%' percent (100% means maximum amplitude)
the gate is activated. If the signal stays below
the threshold for 'th_time' ms, it's faded out dur-
ing the attack phase of 'attack' ms. If the signal
raises above the 'threshold_level' and stays there
over 'hold' ms the gate is released during
'release' ms.
I tried to run -ev over the part I wanted to be muted, then multiply by a
hundred and put it in to the parameters, but this resulted in instant
deactivation of the gate, only allowing peeks that reached 100% through.
Your help is appreciated.
_J
This archive was generated by hypermail 2a24 : Thu Oct 07 1999 - 10:25:25 EEST