Re: [ecasound] control a parameter on commandline

On 14 Jun 2010 15h54 WEST, haarman@gmail.com wrote:

> I am trying to figure out if it is possible to control a plugin
> parameter on the commandline. I have the following command:
>
> ecasound -el:delay_60s,1,1 -i alsahw,0,0 -o alsahw,1,0

AFAIK, you cannot do that with the command line. You can however do
that using the interactive mode.

You enter the interactive mode by issuing ecasound -c

See the ecasound-iam man page. In particular the cop-set command, it
reads:
         cop-set ’chainop_id,param_id,value’
               Changes the value of a single chain operator
               parameter. Unlike other chain operator commands, this
               can also be used during processing. See also
              ’cop-get’
HTH,
--- appa

------------------------------------------------------------------------------
ThinkGeek and WIRED's GeekDad team up for the Ultimate
GeekDad Father's Day Giveaway. ONE MASSIVE PRIZE to the
lucky parental unit. See the prize list and enter to win:
http://p.sf.net/sfu/thinkgeek-promo
_______________________________________________
Ecasound-list mailing list
Ecasound-list@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/ecasound-list
Received on Mon Jun 14 20:15:04 2010