[ecasound] pre4 for 2.5.0

Hi,

ok, usually at this point I write that "this is most probably the last
prerelease for 2.5.0", but well, so far it has not been the case. :)
So ta-daa, here's pre4:

http://ecasound.seul.org/download/snapshots/ecasound-2.4.7pre4_2.5.0.tar.gz

This contains couple of important bugfixes, some nontrivial changes to
signal handling, and one new feature. The new feature is probably easiest
to explain with an example:

sh> ecasound -i foo.wav -o jack_alsa -c -E "setpos 50 ; start"

... that starts with a simple setup, seeks the whole chainsetup to pos
50sec and then starts processing. So pretty simple, but potentially very
useful. Here's the manpage entry:

dit(-E "cmd1 [[args] ; cmd2 args ; ... ; cmdN]")
Execute a set of Ecasound Interactive mode (EIAM) commands
at launch. These commands are executed immediately after
ecasound is started. If the command line contains sufficient
options to create a valid chainsetup that will be executed,
the launch commands are executed after the other command
line options are parsed, but before the processing engine
is started. Note that this command is a feature of
the ecasound frontend binary and not supported by
the library backend. This means that other clients may
not support the '-E' option, and also that the launch
commands are not saved as part of chainsetup or session
state.

-- 
-------------------------------------------------------------------------
Sponsored by: SourceForge.net Community Choice Awards: VOTE NOW!
Studies have shown that voting for your favorite open source project,
along with a healthy diet, reduces your potential for chronic lameness
and boredom. Vote Now at http://www.sourceforge.net/community/cca08
_______________________________________________
Ecasound-list mailing list
Ecasound-list@email-addr-hidden
https://lists.sourceforge.net/lists/listinfo/ecasound-list